Arduino Ethernet Shield clone with W5500

W5100

  1. The W5500 chip is a new part and a Hardwired TCP/IP embedded Ethernet controller that enables easier internet connection for embedded systems using SPI (Serial Peripheral Interface). In these day, Ethernet shield by using W5500 is released.
  2. Arduino Ethernet Shield R3.0 (arduino.cc): Arduino Ethernet Shield is one of arduino official shield and is used the W5100 which is a Hardwired TCP/IP embedded Ethernet controller. W5100 has SPI and BUS interface for host interface.
  3. Arduino Ethernet Shield 2 (arduino.org): Arduino Ethernet shield 2 is used W5500 for Ethernet connectivity. w/ PoE socket, extra 3pin and out with I2C and GPIO
  4. W5500 Ethernet Shield (Seeed): It is used W5500 for Ethernet connectivity. w/o PoE socket, extra 2pin and out with I2C and UART
  5. POE W5500 Ethernet Shield (ITEAD): It is used W5500 for Ethernet connectivity. support PoE, Electonick Brick I/Fs, SPD8001 modules IF, swith for 3.3V and 5V, CS Jumpers
  6. ioShield-A (WIZnet): It is used WIZ550io network module(w/W5500) and has MAC address. not support PoE
  7. W5500 (WIZnet): It is used W5500 for Ethernet connectivity, not support PoE, ARM mbed and Arduino compatible, ETH_CS Jumper and 6 SD_CS, extra 2pin out with I2C and UART
Read next page