Arduino Ethernet and clones

I compared Arduino Ethernet and its clones.

  1. "The Arduino Ethernet is a microcontroller board based on the ATmega328. It has 14 digital input/output pins, 6 analog inputs, a 16 MHz crystal oscillator, a RJ45 connection, a power jack, an ICSP header, and a reset button.
    NB: Pins 10, 11, 12 and 13 are reserved for interfacing with W5100 (Hardwired TCP/IP Chip, wiznet.co.kr) and should not be used otherwise. This reduces the number of available pins to 9, with 4 available as PWM outputs.

    An optional Power over Ethernet module can be added to the board as well. W5100 and should not be used otherwise. This reduces the number of available pins to 9, with 4 available as PWM outputs.

    An optional Power over Ethernet module can be added to the board as well."
  2. Arduino Ethernet (arduino.cc) : Arduino Ethernet
  3. Ethernet Microcontroller (AndyMark) : Arduino Ethernet conmpatible
  4. ZduinoE (Zuduino): Arduino Ethernet compatible, w/ PoE
  5. Ethernet Pro (sparkfun): Arduino Ethernet compatible, w/o PoE
  6. Seeeduino Ethernet (sparkfun): Arduino Ethernet conmpatible, w/o PoE, Extention Header:I2C, UART
  7. EtherTen (Freetronics): Arduino Ethernet compatible, w/PoE, w/ USB socket (for program)
  8. UnoNet+ (SweetPea) : Arduino Ethernet compatible with W5500, w/o PoE, Extension Header : I2C, UART, Two One-Wire
  9. Arduino Leonardo ETH (arduino.org) : Arduino Leonardo compatible with W5500, w/ USB socket
  10. NX bridge (ElecFreeks) : Arduino Leonardo compatible with W5500, w/ XBee adapter
  11. ITEAD (ITEAD) : Arduino Ethernet Clone, w/ PoE, w/ XBee adapter, w/ XBee adapter, nRF24L01+ adapter, not support arduino pin compatible
  12. XBoard V2 (DFRobot) : Arduino Ethernet Clone, ont support arduino pin compatible, w/ USB socket, w/ XBee adapter
  13. Ethernet-NANO (Gravitech): Arduino Nano with W5100, w/o PoE
Read next page